3. Check whether the inlet pipe is sealed step by step, and eliminate the failure of the leak. Â Â Â For more information on sprinkler, sprinkler price, welcome to inquire!
SZB series Vacuum Pump is a cantilever liquid ring vacuum pump, which is used to suction air or other gas that is non-corrosive, unsolvable in water and with no solid powder. The minimum suction pressure is-0.086Mpa. It is widely used in industries such as mechanical, petroleum, chemical, pharmaceutical, food and others. It is especially applicable in to intake water for large pumps.
Email: garfieldlee@vip.163.com Mobile:0086-13777009159
Vacuum Pump Vacuum Pump, Penis Enlargement Vacuum Pump, Vacuum Pump Price, Sex Vacuum Pump, Vacuum Erection Penis Pump, Mini Vacuum Pump NINGBO MARSHINE POWER TECHNOLOGY CO., LTD. , http://www.pump-industry.com
　　
1. Check whether the water pump outlet and outlet switch of the sprinkler pump is turned on. In general , the water pump of a sprinkler is a self-priming pump. When the water is used for the first time, the water should be poured.
2. Check if the filter on the front section of the suction pipe is clogged with water.
　　
4. The water diversion height of the water pump used by common sprinklers should be less than 5 meters.
　　
5. Check if the water pump oil seal of the sprinkler is damaged, and the leakage of the pump shaft affects its vacuum. Replace the seal.
　　
6, the sprinkler engine speed is too low, can not reach the required vacuum, adjust the throttle to make the speed at about 1700 rev / min, the gearbox may require different engine speed.
　　
7. Check whether the power take-off device of the sprinkler is working or not. The power take-off and the drive shaft can cause the water pump to fail to work.
　　
8, check the sprinkler pump speed is normal, there is no abnormal noise. If you can't move it, there is a lot of debris around the blade.
　　
9, in addition to the detection process to avoid long-term idling of the pump, causing the pump temperature is too high affect its life.
　　
When the sprinkler fails to pump water, it may be due to the following reasons.
　　
1. Sprinkler tank Because of the long-term use of uncleaned dirt inside the tank, or the source of water used is too dirty, the outlet strainer or pump body is blocked.
　　
2. If there is a failure of water in the sprinkler during the winter season , it may be considered that the inside of the tank and the water pump of the sprinkler are frozen and cracked to cause the above failure.
When the water pump of the sprinkler cannot absorb water, please refer to the following steps to test the maintenance: